中古 BOC EDWARDS / SEIKO SEIKI IPX 100A #9118208 を販売中

Dry vacuum pump P/N: A409-04-977 Inlet connection: NW40 Outlet connection: NW25 Ambient operating temperature range: 5°C to 40°C Maximum ambient operating humidity: 90% RH @ 20°C, 50% RH @ 40°C Noise: < 59 dB(A) Maximum operating tilt angle: 5° Oil capacity: 0.3 L Warm up time (to nominal performance): 30 minutes Peak pumping speed: M3h-1: 100 Cfm: 58.9 l min-1: 1667 Ultimate vacuum: Mbar: < 5 x 10-3 Torr: < 3.7 x 10-3 Pa: < 0.5 Maximum leak rate: 1 x 10-5 mbar/ls-1 1 x 10-3 Pa/ls-1 2.1 x 10-8 atm/ft3/min-1 Interface connector: Parallel pump interface: AMP 16-way CPC (male) Nominal pin rating: 24 V, 0.25 A Shutdown thermal snap switch: Opening temperature: 80°C, 176°F Closing temperature: 60°C, 140°F Cooling-water supply specification: Maximum supply pressure: 7.89 bar absolute, 7.89 x 105 Pa, 100 psig Minimum required pressure differential across supply / Return: 2.07 bar, 2.07 x 105 Pa, 30 psig Maximum supply temperature: 35°C Minimum supply temperature: 15°C Maximum particle size in supply: 0.03 mm2, 4.6 x 10-5 inch2 Typical heat removed from IPX pump: 2 kW, 6824 btu/hr-1 Nominal water consumption: 2 to 3 l/min, 31.7 to 47.6 US gallons/hr-1 Typical cooling water: 120 l h-1 Connectors: Inlet: 3/8" BSP quick-release (male) Outlet: 3/8" BSP quick-release (female) Model type: Hanson 72 series stainless steel couplings Process gases specification: Typical shaft seal nitrogen flow: 0 slm Pump body: Aluminum LM25 Pump rotor: Hard anodized aluminum PTFE impregnated Internal shaft seals: PTFE coated stainless steel O Rings: Viton fluoroelastomer Bump stop: Stainless steel Pump shaft: Carbon steel Electrical specification: Voltage tolerance: ±10% Electrical power: Full load: 3.6 kW Ultimate vacuum (no load): 2.2 kW Fuse / Isolator rating: 20 A Minimum earth (Ground) cable rating: 32 A Electrical supply plug: Hubble twist lock insulgrip Power: 200/208 V, 3 Phase, 50/60 Hz, 20 A CE Marked 2000 vintage.