中古 EVAPCO LRW 43-4 #9005400 を販売中

Cooling tower, 115 ton Stainless steel Water capacity: 350 GPM, 95°F in, 85°F out, 65°F EWB Fan motor: 15 (inverter duty) HP, elec. spec. 460/3/60 Pump motor: 1.5 HP, elec. spec. 460/3/60 Coil pressure drop: 4.9 PSIG, drives sized for 0" ESP Unit type: hot-dip galvanized steel, factory assembled, counterflow blow-through Basin-fan section: constructed with heavy gauge mill hot-dip galvanized steel Make up float valve assembly: brass float valve with adjustable, foam-filled plastic float Pan strainer: type 304 stainless steel with large area removable perforated screens Fan discharge cowls: G-235 hot-dip galvanized steel cowls provided on each fan discharge Access: G-235 hot-dop galvanized steel circular access doors held in place by wing nuts Bleed-off: waste water bleed line with adjustable valve provided Pump: horizontally installed close-coupled centrifugal pump with mechanical seal Fan wheels: fans forwardly curved centrifugal type, hot-dip galvanized steel factory installed into fan section Fan shaft bearings: solid shaft of ground and polished steel Fan motor: enclosed, ball bearing type with 1.15 service factor Fan drive: V-belt type with taper lock sheaves Fan end inlet screen: hot-dip galvanized steel screens, 1" wire mesh Coil: Thermal-Pak coil design of all prime surface steel, encased in steel framework with entire assembly hot-dop galvanized after fabrication Water distribution system: molded nylon ZM spray nozzles with 1-5/16" diameter opening and internal sludge ring Fan side inlet screen: PVC coated radial screens Heat transfer casing: G-235 hot-dip galvanized steel panel construction, separable from basin section Eliminators: constructed of inert PVC 2006 vintage.